ResourcesGenerator set procurement articles
Diesel vs gas generators for industrial sites
Start with the fuel that can reliably reach the set during the hours it must run. Then compare both packages against the same load profile and operating scenario.

Check what happens during a supply interruption
For diesel, map usable storage, replenishment and delivery access. For gas, ask whether the gas source, regulation equipment and any electrically driven auxiliaries remain available during the outage. For either option, identify a recovery plan for an interrupted fuel supply.
Compare delivered electrical output
Give both suppliers the site altitude, temperature, voltage, frequency and load sequence. Ask each for site-rated output and transient response with the actual fuel. Include treatment or storage, permits, consumables, maintenance and downtime in the cost comparison.
| Decision | Diesel package | Gas package |
|---|---|---|
| Fuel continuity | Usable storage and resupply route | Supply reliability and inlet pressure under load |
| Site works | Tank, containment and fuel transfer | Regulation, treatment and isolation |
| Commercial comparison | Fuel delivery, testing and maintenance | Gas contract, treatment and maintenance |
Next procurement step
Send both bidders the same site and load inputs and ask them to list assumptions about fuel availability.
Technical references
Generator set procurement articles
Prime vs standby generator ratings
Select the duty rating from how the set will run, then compare site-rated electrical output under that duty.
What fuel data belongs in a gas generator RFQ?
Identify the gas and its variability at the proposed equipment boundary. A fuel name alone gives the supplier too little information to confirm a configuration.
How to compare generator set quotations
Put competing quotes on a shared technical and commercial basis before ranking their prices.
Generator set factory acceptance test checklist
Write the test sequence, limits and evidence requirements into the purchase documents so the buyer and factory can agree what counts as a pass.
How to specify data center standby generator sets
Start with the power restoration sequence and the loads each set must accept. Use these inputs to review the generator and switchgear interface with the project electrical team.